[Xy-pic] Draw a partial circle segment
Diego
dgtorpedo at gmail.com
Fri Jun 19 09:48:25 CEST 2015
Hi,
I can't figure out if is possible or not draw a partial circle segment
between to arbitrary direction.
The manual says:
*\cir<radius>{<diag> <orient> <diag>}
I want draw the part of the full circle, with radius 5mm, that starts from
(3.5,3.5) and ends in (2.2,4.5), so I use the command:
(0,0)*\cir<5mm>{v(3.5,3.5)^v(2.2,4.5)}
but it's completely wrong!
Which is the correct syntax?
Thanks.
--
Diego
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://tug.org/pipermail/xy-pic/attachments/20150619/49b530a0/attachment.html>
More information about the xy-pic
mailing list