[Tugindia] RE: Page sizes
Suresh A.L.
sureshal at sps.co.in
Mon Sep 20 13:00:59 CEST 2004
Dear Ragu,
Fine and hope the same. Ragu, I have the small problem
previously also. Please try to solve this,
I have to get a PAGE SIZE of 6 x 9 inches.
If I make the ps like this,
c:\yandy\dvipsone\dvipsone -l=432*638 -*P=432*638 sample.dvi
it is giving on some A4 paper and in the PDF generation it is
croping on right and top and showing 6 x 9 inches.
like like
_________________
| |
| |
| |
| |
| || |
|
|
|
|
|
|
-----Original Message-----
From: Ragu.solaiappan, Integra
[mailto:ragu.solaiappan at integra-india.com]
Sent: Saturday, May 08, 2004 3:35 PM
To: tugindia at tug.org
Subject: [Tugindia] Dvipsone Page sizes
Dear Suresh,
The Dvipsone of YandY takes (rounded) points as the default unit
for all their dvi to PS creations.
The conversion it does is (1/12)*(pt/6)*25.4=mm. When it does such
conversion, you will get different output because of the rounding value.
You cannot escape from this error until you change your default
setting of dvipsone from pt to mm.
dvipsone.exe -l=300*400 -*P=300*400 -f=c:/psfonts %1
The 300, and 400 are all points (unit) for you - where is the mm?
Regards
Ragu
Dear All,
When I make the ps-pdf from the dvi file (with option ==> dvipsone -l=a4
*.dvi), the PDF page is showing slightly shorter pages (209.9 x 296.7mm)
than the a4 paper size. I want the exact size of a4 paper.
And, the measured values in the dviwindo are varying in the PDF output. Is
it, because of the difference between the Measured value and the
calculated value or some thing else.
Any suggestions regarding these will be helpful for me.
Thanking you in advance.
with regards
suresh
_______________________________________________
Home: http://www.tug.org.in/
unsubscribe: http://tug.org/mailman/listinfo/tugindia
More information about the tugindia
mailing list