[tex-k] configure.ac/Makefile.am for vlna
zdenek.wagner at gmail.com
Thu Jul 3 16:16:28 CEST 2008
2008/7/3 Peter Breitenlohner <peb at mppmu.mpg.de>:
> On Thu, 3 Jul 2008, Zdenek Wagner wrote:
>>> Fine. But I have recovered the copy in utils/vlna because it is needed
>>> 'make dist' (at least until Petr provides an updated tarball).
>> I am not sure whether this is good solution. I have the same csplain
>> with the same CS fonts as Petr, so the DVI must be (almost) identical.
>> Only the timestamp at tne DVI header will differ. Anyway, using just
>> vlna.tex is not enough to make vlna.dvi, vlna.idx is needed too. This
>> is created from vlna.w by cweave but it is present neither in Petr's
>> tarball nor in TL svn.
> Hi Zdenek,
> sorry, I missed that point. In fact cweave creates three files: vlna.tex,
> vlna.idx, and vlna.scn. My Makefile removed the last two, but should have
> kept vlna.idx and maybe also vlna.scn.
Yes, vlna.scn is needed too, vlna.toc is created while TeXing. This is
Czech hyphenation used (\language=5). \frenchspacing is set on.) *1 
 *6   *9   *15      *25    *33
        *57 Index: (./vlna.idx ) 
Section names: (./vlna.scn)  Table of contents: (./vlna.toc)  )
Output written on vlna.dvi (26 pages, 82704 bytes).
> Could you please check (and tell me) if vlna.scn is needed. I'll then update
> TL svn and the ftp://ftpth.mppmu.mpg.de/-tarball.
> Best regards Peter
More information about the tex-k